Estimated reading time: 6–9 minutes
Never place any part of your body beneath a Mustang supported only by a jack. Use the exact lifting and support points for the model, rated equipment on a solid level surface, wheel chocks, and a controlled stability check before working underneath.
Browse Mustang parts for this vehicle range while preparing the job.
Safety note: Use Ford service information and the part manufacturer’s instructions for the exact vehicle. Never guess lifting points, torque, fluids, wiring tests, or bleeding procedures. Stop when the job exceeds your tools or experience.
Plan the lift before moving the car
Read the owner and service information for approved points and any special restrictions. Consider lowered ride height, side-exit exhaust, subframe connectors, rust, body damage, convertible reinforcement, and the work that needs suspension loaded or unloaded.
Choose equipment with adequate capacity and reach; do not extend a small jack beyond safe limits.
Prepare the surface and vehicle
Work on solid level concrete when possible. Avoid soil, gravel, slopes, and thin asphalt that can shift or sink. Set the parking brake when compatible with the job, select Park or gear, and chock wheels that remain on the ground.
Loosen wheel fasteners only as the correct procedure allows before lifting.
Lift at an approved point
Center the saddle, raise slowly, watch for slipping or body movement, and stop if the pad deforms damaged metal. Do not use suspension, differential, pinch weld, or subframe points unless the exact vehicle information approves them.
Keep hands and feet away from the jack’s wheels and pivoting arms.
Place stands and lower carefully
Use matched rated stands at approved support points. Lower the car gently until fully seated, remove jack load as instructed, and keep the jack as secondary support only when it does not interfere.
Never stack loose wood, bricks, wheels, or concrete blocks under a stand.
Verify stability and exit plan
Give the vehicle a controlled push from outside at a safe location; it should remain solid. Recheck chocks and contact points before crawling under. Keep an unobstructed path out and another person aware of the work.
Before lowering, account for every tool, stand, chock, hose, and person.
Quick checklist
- Use exact approved lift points
- Work on solid level ground
- Chock remaining wheels
- Use rated matched stands
- Perform a stability check
- Count tools and supports before lowering
Before ordering: Confirm the exact vehicle configuration, tested need, included hardware, and installation requirements.
